All right now, we're getting ready for our other operation and that's a
grooving setup. And the way we're going to do that is by using this, which is
square to the spindle on the machine. Right now this is loose, you can
see it. So what we're going to do is come up against that and it will square this
up and consequently we'll have a nice square groove on there. So just kind of
turn this on an angle like so, and bring out against it, and you'll see it's
starting to straighten it up. There it is. We're now good and straight. We can go
ahead and tighten this like so.
And we're good to make a good square groove. Okay, so now we're going to come
over here,
And we know that the dimension that we made this to, one inch. We know we
did that on the digital readout, so now we're going to come over here after we
squared that up. Okay, zero up, come over here, bring it out, take this over one inch.
Actually I'm going to go two or three thousands past it, to make sure that
we're cleaning that up good. They're about three thousands, okay.
And then we're just going to go in like so. We should shave a little bit off of there.
and our dimension on that groove is
0.420 on that one.
And we're going to check it with our calipers for that diameter, it's 0.420.
Okay, we're good on that, so that's the end of that diameter. Now same scenario here.
Here we're going to come over two and a quarter inches.
And you should have -yep, we have something to skim off there. We're gonna
do the same thing here.
We're going to do that one to 0.630
Okay, we have more to go in yet. We had about 0.705 on that one.
We still have a ways to go.
We've completed number six. We're going to move on to number seven.