Yeah we're going to go one inch back, so here we're going to come over here, just
slightly touch off again, zero everything up.
We're going to come over 1 inch.
We're gonna double-check.
Measure once check three times, right, something like that. Let's put
our line on there.
All right we're ready to take the new diameter down, reduce it.
And this will be it.
All right we know that's our last cut now, so now we're going to crank this out
and straighten that shoulder up if it needs it. Doesn't always need it.
Okay and that should be it on that diameter. Now we're gonna we're going to
turn this to approximately a 45 degree angle to put a chamfer on there. You can
do it with a file too. Let's see if we have enough room to try this here, yeah.
Okay, so we're going to put a little chamfer on there. Just come in like so
with the side of that insert.
There we go you got your chamfer, okay. That's it for that diameter.